25
5.11 TRS Preamp Sends
The TRS sends are designed for use with balanced or unbalanced 1/4”
cables. The sends are direct outputs from the preamp that allow an
external dynamics processor to be placed in the signal chain. For
example, a BlueMAX or similar compressor could be wired in place
between the sends and any of the FIREstationin puts. Proper attention
must be paid so that the sends from the preamp are connected to the
inputs of the external device and the outputs of the device are
connected to the inputs of the FIREstation.
5.12 Main Out
The Main outs are designed for use with Control Room Monitors. The
line mixer dictates the content and volume of these outputs.
To Next Page