Prestige APS57TM - Warranty Information; Limited Lifetime Warranty Details

APS57TM_RevA_07/20
7
Detailed Descripons: Setup Opons
Bank 1: Add / Remove Remote Controls See page 15 for Programming Instrucon.
To Auto Program a remote control:
1. Turn the ignion key to ON.
2. Press and release the valet buon three (3) mes.
3. The system will beep one (1) me, indicang you have accessed Bank 1, Remote Programming.
4. Press the Lock buon of each remote control you wish to program. (Channels 1-3 of the remote control will be
programmed.) The system will beep one (1) me when each remote control is added.
5. Turn the ignion key to OFF to exit programming mode, or cycle the ignion key OFF/ON to advance to the next
Feature Bank.
To delete a remote control:
This system will store a maximum of four (4) remote controls in the memory. Addional programmed remote controls
will delete the oldest-programmed remote control.
Deleng All Remotes:
1. Perform steps 1-3 above.
2. Press and hold the valet buon for ve (5) seconds.
3. The system will sound one (1) long beep. This indicates all remotes have been deleted from memory.
Notes:
• The system will store in the memory a maximum of four (4) remote controls. Addional programmed
remote controls will delete the oldest-programmed remote control.
• During normal operaon, the Programmed Transmier Nocaon (PTN) funcon indicates how many
remote controls are programmed by ashing the LED a certain number of mes when the vehicle ignion is
turned on.
Remote programming is located in Feature Bank 1. This system will Auto Program basic funcons of the remote with one
(1) buon press. Basic funcons are channels 1-3, Lock, Unlock, and Trunk / Start.
1 Auto Program/Lock
2 Unlock
3 Trunk/Start
Feature Bank 1 Descripon
CH.
Press Lock buon on remote
Press Unlock buon on remote
Press Start buon on remote