Prestige APS57TM - Using Your Remote Control; Door Lock and Unlock; Remote Start and Shutdown; Vehicle Interior Climate Control

APS57TM_RevA_07/20
3
Detailed Descripons: Wire Harness Colors and Funcons
Nocaon Connector (4-pin connector) See page 22 for the full system diagram.
These wires are listed in order of their placement in the harness connector.
2. WHITE/RED – Parking Light Relay Input (Internal Relay Pin 87)
The WHITE/RED connects to vehicle 12-Volt (+) or Ground (-) to supply the relay output (WHITE wire).
Vericaon for default seng:
• If the vehicle parking light wire registers 12-Volt (+) when the park lights are on, connect the WHITE/RED wire to a
constant 12-Volt (+) vehicle wire.
• If the vehicle parking light wire registers Ground (-) when the park lights are on, connect the WHITE/RED wire to a
reliable vehicle ground source.
1. WHITE – Parking Light Relay Output (Internal Relay Pin 30)
At its default seng, the WHITE wire supplies 12-Volt (+) or Ground (-) to the vehicle's park light wire based on the
connecon of the relay input (WHITE/RED wire).
Vericaon: The vehicle parking light wire registers 12-Volt (+) or Ground (-) when the park lights are turned on.
4. BLACK – Ground Input (-)
The BLACK wire connects to a reliable vehicle ground (-) source to power the system.
Vericaon: The vehicle ground (-) source wire registers ground (-) at all mes.
Note: Before making this connecon, remove all module fuses unl the system is completely connected.
3. YELLOW/BLACK – Ignion Output to Alarm (+)
The YELLOW/BLACK wire supplies 12-Volt (+) ignion output when the vehicle's ignion is set to ON, but not during the
remote start runme. This output will be used when an external alarm system is added to the vehicle.
1
3
2 4