Prestige APS57TM - Wire Harness Colors and Functions; Power Connector

APS57TM_RevA_07/20
2
Detailed Descripons: Wire Harness Colors and Funcons
Power Connector (6-pin High-Current Connector) See page 22 for the full system diagram.
These wires are listed in order of their placement in the harness connector.
1. YELLOW – Starter Output for Remote Start (+)
The YELLOW wire supplies 12-Volt (+) to the vehicle’s starter wire when remote start is enabled, and turns o once the
vehicle is started.
Vericaon: This starter wire registers 12-Volt (+) during engine crank.
3. RED – 12-Volt Input (+)
The RED wire connects to the vehicle’s primary 12-Volt (+) wire to power the system.
Vericaon: The power wire registers 12-Volt (+) at all mes.
Note: Before making this connecon, remove all module fuses unl the system is completely connected.
2. GREEN – Ignion 2 Output (+)
At its default seng, the GREEN wire supplies 12-Volt (+) to the vehicle’s secondary ignion wire during remote start.
Vericaon: If present, the secondary ignion wire registers 12-Volt (+) when the vehicle is in ignion mode AND during
engine crank.
Note: This wire can be programmed to perform a dierent funcon by changing its opons. Refer to Bank 3, Feature 7
on page 10.
4. RED/WHITE – 12-Volt Input (+)
The RED/WHITE wire connects to the vehicle’s secondary 12-Volt (+) wire to power the remote start funcon.
Vericaon: The power wire registers 12-Volt (+) at all mes.
Note: Before making this connecon, remove all module fuses unl the system is completely connected.
1 3 5
2 4 6
6. BLUE – Ignion 1 Input / Output (+)
The BLUE wire supplies 12-Volt (+) to the vehicle’s primary ignion wire during remote start. This wire is also used to
sense vehicle ignion for the Programming Funcons
Vericaon: The primary ignion wire registers 12-Volt (+) when the vehicle is in ignion mode AND during engine crank.
5. PURPLE – Accessory Output (+)
At its default seng, the PURPLE wire supplies 12-Volt (+) to the vehicle’s accessory wire to power vehicle accessories
during remote start.
Vericaon: The accessory wire registers 12-Volt (+) when the vehicle is running or in Accessory mode, but not during
engine crank or if the vehicle is o.
Note: This wire can be programmed to perform a dierent funcon by changing its opons. Refer to Bank 3, Feature 9
on page 10.