Technical specifications - Mechanical
Technical specifications - mechanical
The illustrations and tables in this chapter show the dimensions of the NutriJet. Please read the
explanation first:
General explanation:
• All dimensions in the tables are in millimetres unless specified otherwise.
• Dimensions of unions are measured up to the outside of the union.
Dimensions of flanges are measured up to the gasket.
• W1.1 and W1.2 are the dimensions up to the two pre-mixing inlets.
• 1C stands for a single mixing chamber.
2C stands for a double mixing chamber.
Explanation of letters in tables:
a. Metric inlets and outlets can be converted to nominal imperial sizes in accordance with table
Inlets and outlets: metric > nominal imperial (page 47).
b. Dimensions of the frame
c. Height of the unit with CE cabinet is 1315 mm (unless H3 is higher). See also letter i.
Height of the unit with CSA/UL cabinet 37" is 1180 mm (unless H3 is higher). See also letter i.
Height of the unit with CSA/UL cabinet 49" is 1485 mm (unless H3 is higher). See also letter i.
d. If the unit has a double mixing chamber, then +500 mm
e. If the unit has a double mixing chamber, then +656 mm
f. If the unit has inlet valves, then +91.5 mm
g. If the unit has imperial unions, then +20 mm
h. If the unit has imperial unions, then +39 mm
i. The adjustable legs can be used to adjust the height of the unit by 41 to 51 mm (H0).
j. If the unit has imperial unions and a frequency controller, then +188 mm
If the unit has imperial unions and no frequency controller, then +20 mm
Inlets and outlets: metric > nominal imperial
Nominal size BSP screw thread
(inches)
Nominal size of union (inches)Ø (mm)
1.51.550
2263
2.53 *75
3390
44110
* Because a nominal size of 2.5 inches is not common with imperial piping, Ø 75 mm is converted to 3 inches
nominal with a special adapter set. See also letters g and h in Explanation of letters in tables.
47NutriJet - user - 00.002
Appendices
To Next Page
Loading...