The heating modesPage EN-24
When the time indicator reaches
00:00
, a
signal sounds five times and the appliance
switches off.
Cooking time correction:
1. Briefly press the “Clock” sensor button
(17).
2. Set the cooking time using the rotary
switch (20).
Power level correction:
1. Briefly press the “Temperature/weight” sen-
sor button (18).
2. Set the power level using the rotary
switch (20).
Grill mode
Grilling is best for cooking thin portions of
meat or fish.
1. Place the dish in the cooking chamber and
close the cooking chamber door (3).
2. Use the function selector (12) on the dis-
play (16) to select the “Grill” indicator
.
The display (16) shows the cooking time in-
dicator
20:00
min as well as the grill level
indicator 3. The grill level indicator flashes.
(20)(12) (19)(18)(17)(16)
3. If required, use the rotary switch (20) to
change the grill level.
Possible values: 1 (low) to 3 (high).
4. To change the cooking time, briefly press
the “Clock” sensor button
(17) and set
the cooking time with the rotary switch (20).
5. Press the “Start” sensor button
(19).
The appliance will start, the fan will switch
on and the time indicator will start to count
down.
When the time indicator reaches
00:00
, a
signal sounds five times and the appliance
switches off.
Cooking time correction:
1. Briefly press the “Clock” sensor button
(17).
2. Set the cooking time using the rotary
switch (20).
Power level correction:
1. Briefly press the “Temperature/weight” sen-
sor button (18).
2. Set the power level using the rotary
switch (20).
Combination mode
The heating modes
–Convection
–Grill with fan
–Grill
can both be combined with microwave mode.
This allows you to make full use of the bene-
fits of the different heating modes and the mi-
crowave. It lets you cook quickly and produce
a nice crust at the same time. This shortens
preparation times enormously.
The microwave power is limited to
a maximum of 700 watts and the
cooking time to a maximum of 1
hour and 30 minutes because of the inten-
sive heating mode.
To Next Page
Loading...
