8
7
Battery Cover
Batteries
16
7. The Console (16) can use four 1.5V “D” batteries
(not included); alkaline batteries are recommended.
IMPORTANT: If the Console has been exposed
to cold temperatures, allow it to warm to room
temperature before inserting batteries.
Otherwise, you may damage the console dis-
plays or other electronic components. Remove
the battery cover and insert the batteries into the
battery compartment. Make sure to orient the bat-
teries as shown by the diagram inside the
battery compartment. Then, reattach the battery
cover.
To purchase an optional power adapter, contact
the store where you purchased this product or
call the telephone number on the cover of this
manual. To avoid damaging the console, use
only a manufacturer-supplied power adapter.
Plug one end of the power adapter into the recepta-
cle on the console; plug the other end into an outlet
installed in accordance with all local codes and ordi-
nances.
12
55
55
55
7
6
49
2
49
6. Have another person hold the Seat Frame (7) under
the Rear Frame (2) as shown. Attach the Seat
Frame and the Seat (12) to the Rear Frame with
f
our M6 x 42mm Button Screws (49) and four M6
Washers (55).
See step 4. Tighten the two M8 x 70mm Button
Bolts (54).
See step 5. Tighten the four M6 x 38mm Patch
Screws (48).
To Next Page
Loading...
Need help?
General
