26
MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the exercise bike is used.
Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild soap. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
CONSOLE TROUBLESHOOTING
The console requires activation. If you have not
activated the console, see assembly step 16 on
page 14.
If the console does not display your heart rate when
you use the handgrip heart rate monitor, see step 8 on
page 20.
If a replacement power adapter is needed, call the
telephone number on the cover of this manual.
IMPORTANT: To avoid damaging the console, use
only a manufacturer-supplied regulated power
adapter.
TABLET HOLDER TROUBLESHOOTING
If the tablet holder does
not stay in place, rotate
the tablet holder backward
and tighten the screw (A)
until the tablet holder stays
in place when it is rotated
to the desired position.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the
reed switch,
first unplug the
power adapter.
Using a standard
screwdriver,
carefully remove
the Shield Cover
(26) from the
Left and Right
Shields (37, 58).
Next, locate the Reed Switch (64). Slightly loosen the
M4 x 19mm Screw (65).
Next, rotate the Left Crank Arm (35) until a Magnet (54)
is aligned with the Reed Switch (64). Slide the Reed
Switch slightly toward or away from the Magnet. Then,
retighten the M4 x 19mm Screw (65).
Plug in the power adapter and rotate the Left Crank
Arm (35) for a moment. Repeat these actions until the
console displays correct feedback.
When the reed switch is correctly adjusted, reattach
the shield cover.
A
26
37, 58
65
35
64
54
MAINTENANCE AND TROUBLESHOOTING
To Next Page
Loading...
Need help?
General
