To Next PageTo Next Page
What to do if Pro-Form Treadmill power turns off during use?
If your Pro-Form Treadmill's power turns off during use, check the power switch. If the switch has tripped, wait five minutes, and then press it back in. Also, ensure the power cord is properly plugged in; if it is, unplug it, wait five minutes, and plug it back in. Finally, try removing and reinserting the key from the console.
How to fix Pro-Form Treadmill that does not turn on?
If your Pro-Form Treadmill doesn't turn on, ensure the power cord is plugged into a properly earthed outlet and that the key is inserted into the console. If the power switch protrudes, it may have tripped. To reset it, wait five minutes, then press the switch back in.
How to center the walking belt on a Pro-Form Treadmill?
If the walking belt on your Pro-Form Treadmill is not centered between the foot rails, first remove the key and unplug the power cord. If the belt has shifted to the left, use the hex key to turn the left idler roller screw clockwise 1/2 of a turn; if it has shifted to the right, turn the left idler roller screw counterclockwise 1/2 of a turn.
Why is the walking belt slipping on my Pro-Form Treadmill?
If the walking belt on your Pro-Form Treadmill slips when walked on, first remove the key and unplug the power cord. Then, using the hex key, turn both idler roller screws clockwise, 1/4 of a turn.
What to do if Pro-Form Treadmill walking belt slows when walked on?
If the walking belt slows down when you walk on your Pro-Form Treadmill: * Ensure that if an extension cord is needed, it is a 3-conductor, 14-gauge (1 mm[2]) cord no longer than 5 ft. (1.5 m). * If the walking belt is overtightened, remove the key and unplug the power cord. Using the hex key, turn both idler roller screws counterclockwise, 1/4 of a turn.
How to recalibrate incline on Pro-Form Treadmill?
If the incline of your Pro-Form Treadmill does not change correctly, hold down the Stop button and the Speed increase button, insert the key into the console, and then release the Stop button and the Speed increase button. Next, press the Stop button, and then press the Incline increase or decrease button. The treadmill will automatically rise to the maximum incline level and then return to the minimum level to recalibrate the incline system.
How to turn off demo mode on Pro-Form Treadmill?
To turn off the demo mode on your Pro-Form Treadmill, hold down the Stop button for a few seconds. If the displays are still lit, see THE INFORMATION MODE on page 19 to turn off the demo mode.
General