Pro-Form 850 Elliptical - Page 7

7
4. While a second person holds the Console (4)
near the Upright (3), connect the console wire to
the Wire Harness (46). Insert the excess wire
downward into the Upright.
Tip: Avoid pinching the wires during this
step. Attach the Console (4) to the Upright (3)
with four M4 x 16mm Screws (80).
4
80
3. Identify the Upright (3) and orient it as shown.
Have a second person holds the Upright near
the top of the Frame (1). Locate the wire tie
(
see the inset drawing) in the Upright. Tie the
lower end of the wire tie to the Wire Harness
(
46). Next, pull the upper end of the wire tie
upward out of the top of the Upright. Then, untie
and discard the wire tie. Tip: Do not allow the
Wire Harness to fall into the Upright. Use a
piece of tape or an elastic band to hold the
Wire Harness in place until step 4.
Tip: Avoid pinching the Wire Harness (46)
during this step. Insert the Upright (3) into the
Frame (1). Attach the Upright with four M8 x
19mm Patch Screws (65).
3
3
4
46
46
Console Wire
3
1
65
65
Avoid pinching the
Wire Harness (46)
during this step
Avoid pinching the
wires during this step
Wire Tie
46