7
ASSEMBLY
2. Make sure that the power cord is unplugged.
Carefully raise the Right Upright (81) to the verti-
cal position.
Next, start a 3/8" x 2 1/4" Screw (1) and a
3/8" x 3/4" Screw (3) into the Base (90) and the
Right Upright (81) as shown; start both Screws,
and then tighten them.
Repeat this step on the left side of the
treadmill.
3
90
81
1
2
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you nish all assembly steps.
• After shipping, there may be an oily substance
on the exterior of the treadmill. This is normal. If
there is an oily substance on the treadmill, wipe
it off with a soft cloth and a mild, non-abrasive
cleaner.
• To identify small parts, see page 6.
• Left parts are marked “L” or “Left” and right parts
are marked “R” or “Right.”
• Assembly requires the following tools:
the included hex keys
one Phillips screwdriver
To avoid damaging parts, do not use power tools.
1
1. To register your product and activate your
warranty in the UK, go to iconsupport.eu. If you
do not have internet access, call Member Care
(see the front cover of this manual).
To register your product and activate your
warranty in Australia, email or post the
following information to the email address or
postal address on the front cover of this manual.
• your receipt (make sure to keep a copy)
• your name, address, and telephone number
• the model number, serial number, and name
of your product (see the front cover of this
manual)
To Next Page
Loading...
Need help?
General