7
ASSEMBLY
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materialsuntilyounishallassemblysteps.
• After shipping, there may be an oily substance on
the exterior of the treadmill. This is normal. If there
is an oily substance on the treadmill, wipe it off
with a soft cloth and a mild, non-abrasive cleaner.
• Left parts are marked “L” or “Left” and right parts
are marked “R” or “Right.”
• To identify small parts, see page 6.
• Assembly requires the following tools:
the included hex keys
one adjustable wrench
one Phillips screwdriver
scissors
needlenose pliers
To avoid damaging parts, do not use power tools.
1. Make sure that the power cord is unplugged.
Locate the Upright Wire (77) bundled around the
front of the Base (86). Cut the plastic tie securing
the Upright Wire. Then, route the Upright Wire
out of the indicated hole.
Press a Base Cap (81) into each side of the
Base (86).
See the inset drawing. Cut the plastic tie near
the Upright Wire (77). Be careful not to dam-
age the Upright Wire.
77
86
Hole
Cut
77
Tie
Cut
1
81
To Next Page
Loading...
Need help?
General