12
10
10. The Console (5) requires three AA batteries (not
included); alkaline batteries are recommended.
Do not use old and new batteries together or
alkaline, standard, and rechargeable batter-
ies together. IMPORTANT: If the Console has
been exposed to cold temperatures, allow
it to warm to room temperature before you
insert batteries. Otherwise, you may dam-
age the console displays or other electronic
components.
Press the tab on the battery cover (E), and
remove the battery cover. Next, insert three bat-
teries into the battery compartment; make sure
to orient the batteries as shown by the dia-
gram inside the battery compartment. Then,
reattach the battery cover.
E
5
11. Orient the Mount (F) as shown. Pull the Mount
open slightly and slide it onto the center of
the Handlebar (4). Attach the Mount with an
M4 x 25mm Screw (6) and an M4 Nut (26); do
not fully tighten the Screw yet.
11
6
5
6
F
G
4
26
F
12
12. Tip: Avoid pinching the Console Wire (G).
Slide the Console (5) onto the Mount (F). Next,
pivot the Console and the Mount to the desired
angle. Then, tighten the M4 x 25mm Screw (6).
To Next Page
Loading...
Need help?
General
