11
8. With the help of a second person, hold the con-
sole assembly (E) near the Right Handrail (84)
and the Left Handrail (not shown).
See the inset drawing. Connect the Upright
Wire (81) to the console wire. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and
try again. IF YOU DO NOT CONNECT THE
CONNECTORS PROPERLY, THE CONSOLE
MAY BECOME DAMAGED WHEN YOU TURN
ON THE POWER. Then, remove the wire tie (A)
from the Upright Wire.
8
E
81
A
Console
Wire
81
84
9. Set the console assembly (E) on the Right and
Left Handrails (84, 85). Make sure that no
wires are pinched. Insert the excess Upright
Wire (81) into the Right Upright (90).
Attach the console assembly (E) to the brackets
on the Handrails (84, 85) with the four 1/4" x
1/2" Screws (2) that you removed in step 7 and
four 1/4" Star Washers (26); do not tighten the
Screws yet.
9
90
E
2
2
81
84
26
26
Console
Wire
85
To Next Page
Loading...
Need help?
General