Pro-Form SR20 - Attaching the Rear Stabilizer; Installing the Handlebar and Console; Connecting Console Wiring

5
2. While another person lifts the back of the Frame (1)
slightly, attach the Rear Stabilizer (30) to the Frame
with two M10 x 75mm Carriage Bolts (33) and two
M10 Black Nylon Locknuts (34).
33
30
1
3
15
46
46
34
6
13
3. Attach the Handlebar (15) to the Upright (13) with two
M10 x 42mm Button Bolts (6), two M10 Split Washers
(46), and two M10 Black Nylon Locknuts (34).
2
4
34
34
5. Hold the Console (16) near the Upright (13). Insert the
console cable and the console wire into the indicated
hole and down through the Upright. Attach the ground
wire to the Upright with an M4 x 16mm Screw (32).
Insert the excess wire and cable into the Upright (13).
Attach the Console (16) to the Upright with four M4 x
16mm Screws (32). Make sure that the wires and
the cable are not pinched.
4. The Console (16) requires three “AA” batteries (not
included); alkaline batteries are recommended. Insert
three batteries into the Console as shown. Make sure
that the batteries are oriented as shown by the dia-
gram inside the Console.
16
Batteries
32
32
Ground
Wire
Console
Wire
Console
Cable
13
16
5
Hole
32