9
6. Apply grease to the axle on the right side of the
Upright (2).
I
dentify the Right Upper Body Arm (9), which is
marked with a “Right” sticker, and orient it as
s
hown.
Slide the Right Upper Body Arm (9) onto the
right side of the Upright (2).
Attach the Right Upper Body Arm (9) with an
M8 x 18mm Patch Screw (80) and an M8
Washer (33). Do not tighten the Patch Screw
yet.
Repeat this step to attach the Left Upper
Body Arm (8).
7
6
9
77
76
11
8
Hexagonal
Holes
7. With the help of a second person, slide the
Right Upper Body Leg (6) onto the Right Upper
Body Arm (9).
Attach the Right Upper Body Leg (6) with two
M8 x 45mm Button Bolts (76) and two M8
Locknuts (77). Make sure that the Locknuts
are in the hexagonal holes.
Attach the Left Upper Body Leg (11) to the
Left Upper Body Arm (8) in the same way.
See step 6. Tighten the M8 x 18mm Patch
Screws (80).
6
8
9
2
80
33
Grease
To Next Page
Loading...
Need help?
General
