V1.0 145A MULTI-PROCESS MIG-ARC-TIG WELDER 8619470
Visit www.princessauto.com for more information 11
5. Make sure to locate the cord so that it is not stepped on, tripped over or otherwise subject
to damage or stress.
6. Do not wrap the cord around the tool, as sharp edges may cut insulation or cause cracks if
wound too tight. Gently coil cord and either hang on a hook or fasten with a device to keep
cord together during storage.
ELECTROMAGNETIC FIELDS
WARNING! Stop welding immediately and move away from the welding unit if you feel faint,
dizzy, nausea or shocks. Seek medical attention.
Electromagnetic Fields (EMF) can interfere with electronic devices such as pacemakers.
Anyone with a pacemaker should consult with their doctor before working with or near an arc
welding unit. The following steps can minimize the effects of electromagnetic fields.
1. Twist or tape cables together and prevent coils.
2. Do not drape cables on your body.
3. Keep the welding power source and cables as far away from the user as practical. A
minimum of 24 in. is recommended.
4. Connect the workpiece clamp as close to the weld as possible, but lay the electrode and
workpiece cables away from the user.
5. Use the lowest current setting possible during welding.
6. Avoid long and regular bursts of energy while welding. Apply the electrode in short strokes
and intermittently. This will prevent the pacemaker from interpreting the signal as a rapid
heartbeat.
7. Do not allow the electrode to touch the metal while welding.
8. Keep the lead cable and ground cables on the same side of your body.
9. Do not weld while carrying the welding power source.
10. Do not work next to, sit or lean on the welding power source.
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace the missing part before
operating. Failure to do so could result in a malfunction and personal injury.
Remove the parts and accessories from the packaging and inspect for damage. Make sure that
all items in the parts list are included.
Contents:
• 145 Multi-Process MIG-ARC-TIG Welding Unit
• Ground Lead and ARC Lead Set
• 2 V-Groove Drive Rollers, 0.6 to 0.8 mm and 0.8 to 1.0 mm
• MIG Torc h
• 115V/230V Adapter
• Regulator
The compatible MIG Welding Torch (SKU 8613002), Multi-System TIG Torch (SKU 8618456) and
200A Spool Gun Kit (SKU 8612517) are sold separately.
To Next Page
Loading...
