©2022 Pro-Vision Solutions, LLC. Page 43 of 56
BODYCAM 4 Configuration:
The camera configuration must be set to allow it to be activated by
vehicle DVR units. A secondary option Activate camera from devices?
My Organization / All Compatible
DVR-908 System Configuration:
This DVR signal can be set to broadcast when a trigger on the In-Car
system is active. It is typically configured to be broadcasting when the
overhead flashing lights are active but can be configured to be
activated from any of the systems triggers. To enable this functionality,
the in-car system must be set to broadcast when triggered.
1. Connect to the DVR unit and navigate to the “Remote
Activation” settings page.
2. Turn on the “Activate Remote Devices” switch.
3. Choose the desired triggers that will activate the cameras from
the “Triggers” dropdown.
4. Press “Apply” to apply and save the changes.
Test the function by enabling the trigger; the “Remote Activation Status” should
change from “Idle” to “Broadcasting”.
Storage
Disk Information:
This area shows the memory available and free on the SSD or SD card.
Format:
This button will format the disk and erase all previously stored data.
File Explorer:
This area allows the user to browse the storage disks and remotely view and
download files.
1. Choose the disk (SD or SSD) and click on it to open it.
2. The disk will contain log files that can be viewed, or you can choose the “Video” or “Alarm” folder to begin
navigating the video file storage.
3. Each file will have two options on the right side:
a. Press the “Open” button to open the file in your web browser (If supported).
b. Press the “Download” button to download the file to your device for local playback.
To Next Page
Loading...