Pro Vision DVR-908 - Page 54

DVR-908
System Guide
Rev. C - 8/11/2022
©2022 Pro-Vision Solutions, LLC. Page 53 of 56
Problem
Possible Causes
Solution
Able to connect to the Wi-Fi but
cannot access the DVR.
The device is configured with an
incorrect static IP.
Ensure that the network settings of the devices Wi-Fi are set to
DHCP rather than a static IP.
The web path was entered
incorrectly.
Ensure the web address of 192.168.10.254 was entered.
The DVR’s Wi-Fi AP has DHCP
disabled.
Enter a static IPv4 address of 192.168.10.100 mask of 255.255.255.0
and then connect to the DVR. Go to the Wi-Fi settings and re-enable
DHCP.
DVR’s Wi-Fi Client does not find
the buildings Wi-Fi.
The buildings Wi-Fi is out of range of
the DVR.
Relocate the vehicle, reposition the antennas on the building and/or
the vehicle.
The buildings Wi-Fi is using an
unsupported name format.
Ensure the buildings Wi-Fi SSID name is not using spaces or special
characters.
DVR’s Wi-Fi Client will not
connect the buildings Wi-Fi.
The signal strength is poor of the
building’s Wi-Fi AP.
Relocate the vehicle, reposition the antennas on the building and/or
the vehicle.
The security key was incorrectly
entered.
Find the Wi-Fi AP again and reenter the security key.
The security mode of the buildings
Wi-Fi AP is not compatible with the
DVR.
Change the security mode setting of the buildings Wi-Fi AP.
DVR Status Lights
LED Light
Indication
Description
STATUS
(RED/GREEN LED)
- DVR
- Event Button
OFF
No power to DVR, or no power to Event Button.
FLASHING GREEN
DVR is booting up or is booted up but not set to record.
ON SOLID GREEN
DVR is recording, DVR is working properly.
FLASHING RED
DVR cannot record, SD card issue, camera issue.
4G
(AMBER LED)
OFF
No power to DVR, no 4G modem, 4G is disabled, or 4G has not yet booted.
ON SOLID
4G is connected and available for data transfer.
FLASHING
4G is connected and transferring data to/from DVR.
PWR
(GREEN LED)
OFF
No power to DVR.
ON SOLID
Ignition Accessory Signal Detected and DVR is booting/booted.
FLASHING
System has no ignition signal and is in a standby/delayed shutoff state.
RUN
(GREEN LED)
OFF
No power to DVR.
ON SOLID
System error state, unplug then reconnect power to reset.
FLASHING
Delayed shutoff if flashing with PWR, standby if flashing opposite PWR.
Wi-Fi
(AMBER LED)
OFF
No power to DVR, Wi-Fi is disabled or not yet booted.
ON SOLID
Wi-Fi is running and ready for connection(s).
FLASHING
Wi-Fi is connected and transferring data to/from DVR.
SYS
(AMBER LED)
OFF
No power to DVR, system not yet booted.
ON SOLID
System Processor is running and ready for operation.
FLASHING
System Processor is in operation.
SD
(RED LED)
OFF
No power to DVR, No SD Card Inserted, SD Card is not detected.
ON SOLID
SD Card has been detected and loaded by DVR.
FLASHING
SD Card has been loaded and transferring data to/from DVR.
SSD
(RED LED)
OFF
No power to DVR, No SSD inserted, SSD is not detected.
ON SOLID
SSD has been detected and loaded by DVR.
FLASHING
SSD has been loaded and transferring data to/from DVR.