*Due to occasional product upgrades, this manual is for reference only.
10
5.Machine Installation And Setting
5.1 Installation of waste ink bottle
a. Unscrew the screws
b. Thread the plastic tube into the waste ink
bottle
c. Fasten the screws
5.2 Put one sheet PET film for
testing
P.S. The side with matte of pet film
must put on the front side.
5.3 Put a pet film into the feeder and press
the button of paper shortage to test the
feeder
5.4 Set the preheating temperature
between 35°C to 45°C
5.5 Install the pet film tray 5.6 Install the pet film reel
5.7 Install the battery to display
P.S.Need to buy an LR44 button battery
5.8 Fill the ink respectively
according to the color instructions
5.9 Inject the inks into the ink
cartridges.Use syringes glue syringe
needles and draw out 2-3ml ink from each ink
sarcs respectively.
P.S. Try to avoid the outflow of ink
and hold the hard part of ink sac
during Operation
5.10 Guide the waste ink to the waste ink bin 5.11 Print the test strip
P.S.The test strips need to be clear
and complete
To Next Page
Loading...
