AIR FILTER
THE ICE MAKER IS EQUIPPED WITH AN AIR FILTER
TO PREVENT DIRT AND DUST ENTERING THE
CONDENSER. IT IS IMPORTANT THAT THE AIR
FILTER IS CLEANED TWICE A MONTH TO ENSURE
EFFICIENT OPERATION OF THE ICE MAKER.
IMPORTANT: FAILURE TO CLEAN THE AIR FILTER
WILL INVALIDATE YOUR WARRANTY AND MAY
CAUSE A COMPONENT FAILURE.
TO CLEAN YOUR AIR FILTER SLIDE THE FILTER OUT
FROM THE FRONT GRILL AND REMOVE ANY DUST
OR DIRT USING A SOFT BRUSH AND A VACUUM
CLEANER. IF THE AIR FILTER IS HEAVILY BLOCKED
WE RECOMMEND USING WATER AND A MILD
DETERGENT TO CLEAN THE FILTER.
IMPORTANT: AIR FILTER MUST BE CLEAN AND
DRY BEFORE REPLACING INTO THE MACHINE.
IMPORTANT: DO NOT OPERATE YOUR ICE MAKER
WITHOUT THE AIR FILTER IN PLACE
PART IV
WARNING
FAILURE TO CLEAN YOUR AIR FILTER COULD
CAUSE COMPONENT FAILURE AND WILL
INVALIDATE YOUR WARRANTY.
CONDENSER CLEANING
A DIRTY OR CLOGGED CONDENSER WILL PREVENT
PROPER AIR FLOW. THIS WILL LEAD TO REDUCED
EFFICIENCY, REDUCED ICE PRODUCTION AND
AN INCREASE IN OPERATING TEMPERATURE
WHICH MAY LEAD TO COMPONENT FAILURE.
WE RECOMMEND THE CONDENSER IS CLEANED
EVERY SIX MONTHS BY A QUALIFIED ENGINEER.
TO CLEAN THE CONDENSER DISCONNECT THE
ICE MAKER FROM THE MAINS ELECTRICITY.
REMOVE THE SCREWS FROM THE BOTTOM
PANEL AND GENTLY REMOVE THE GRILL.
REMOVE DIRT AND DUST FROM THE CONDENSER
FINS WITH A SOFT BRUSH AND VACUUM CLEANER.
REATTACH THE FRONT GRILL AND RECONNECT
POWER TO THE MACHINE.
CL200718UM Rev 1.3
8
WATER DISTRIBUTOR CLEANING
IF YOUR ICE CUBES ARE NOT FORMING CORRECTLY
OR THE OUTPUT OF ICE CUBES DROPS THE WATER
DISTRIBUTOR MAY BE BLOCKED AND REQUIRE
CLEANING.
DISCONNECT THE ICE MAKER FROM THE MAINS
ELECTRICITY.
SLIDE THE AIR FILTER OUT FROM THE SIDE OF THE
FRONT GRILL ASSEMBLY.
LOOSEN THE SCREWS FROM UNDERNEATH THE
FRONT GRILL AND REMOVE THE PANEL.
REMOVE THE LOWER HINGE ASSEMBLY AND
DOOR.
LOOSEN THE SCREWS HOLDING THE TOP COVER
AT THE FRONT AND REAR AND REMOVE THE
PANEL.
TAKE CARE WHEN REMOVING THE TOP COVER
NOT TO DAMAGE THE WIRING FOR THE CONTROL
PANEL.
THE WATER DISTRIBUTOR TUBE WILL BE VISIBLE,
ROTATE THE TUBE SO THAT THE HOLES ARE FACING
UPWARDS. CLEAN OUT THE HOLES WITH A SMALL
BRUSH AND A SOLUTION OF WARM WATER AND
MILD DETERGENT.
AFTER CLEANING RINSE THE TUBE WITH CLEAN
WATER AND RETURN IT TO ITS ORIGINAL POSITION.
REPLACE THE TOP PANEL, HINGE, DOOR, GRILL
PANEL AND AIR FILTER.
PUT THE MACHINE THROUGH A CLEAN CYCLE TO
ENSURE ALL DEBRIS IS FLUSHED THROUGH.
DISCARD ANY ICE MADE FOR THE FIRST 3 HOURS
AFTER CLEANING TO ENSURE YOU HAVE DISPOSED
OF ANY CONTAMINATED ICE.
WARNING
WATER DISTRIBUTOR CLEANING MUST BE
UNDERTAKEN BY A QUALIFIED ENGINEER.
WARNING
DISCARD ANY ICE MADE FOR THE FIRST 3
HOURS AFTER WATER DISTRIBUTOR CLEANING.
WARNING
ALWAYS WASH YOUR HANDS BEFORE TAKING
ICE FROM THE ICE MAKER
To Next Page
Loading...
