PART IV
WARNING
AFTER LONG TERM STORAGE OR TRANSPORT
YOU NEED TO FOLLOW ALL INSTRUCTIONS IN
PART II OF THIS INSTRUCTION MANUAL WHEN
REINSTALLING THE MACHINE.
CL200718UM Rev 1.3
9
PREPARING YOUR ICE MAKER FOR LONG TERM
STORAGE OR MOVING
IF THE ICE MAKER NEEDS TO BE STORED FOR A
LONG PERIOD OF TIME OR IT NEEDS TO BE MOVED
TO A NEW LOCATION THE WATER SYSTEM WILL
NEED TO BE FULLY DRAINED.
PUT THE ICE MAKER INTO STANDBY MODE
AND DISCONNECT THE UNIT FROM THE MAINS
ELECTRICITY.
TURN OFF THE MAINS WATER SUPPLY AND
DISCONNECT THE WATER INLET HOSE.
REMOVE ALL REMAINING ICE FROM THE STORAGE
BIN.
DISCONNECT THE SILICON HOSE FROM THE
WATER RESERVOIR TO TOTALLY DRAIN THE
WATER SYSTEM. WHEN ALL WATER IS DRAINED
RECONNECT THE HOSE TO THE WATER TANK.
CLEAN THE INSIDE OF THE ICEMAKER AND
THOROUGHLY DRY THE INSIDE WITH PAPER
TOWELS.
FOR TRANSPORTING TO A NEW LOCATION
TAPE THE DOOR SHUT WITH A LOW TACK TAPE
(MASKING TAPE).
FOR LONG TERM STORAGE LEAVE THE DOOR OPEN
AT LEAST 50MM TO ALLOW FOR AIR FLOW INTO
THE ICE MAKER. THIS WILL PREVENT MOLD AND
MILDEW FORMING.
ICE PRODUCTION SYSTEM
MINERALS AND LIME SCALE THAT ARE PRESENT IN
THE WATER ARE REMOVED DURING THE FREEZING
CYCLE AND WILL BUILD UP IN ICE PRODUCTION
SYSTEM. CLEANING THE SYSTEM REGULARLY WILL
HELP TO REMOVE THE LIME SCALE BUILD UP. WE
RECOMMEND CLEANING THE ICE PRODUCTION
SYSTEM EVERY SIX MONTHS WITH A CITRIC ACID
SOLUTION.
WARNING
DE-SCALING MUST BE CARRIED OUT BY A
QUALIFIED ENGINEER.
WARNING
WE RECOMMEND FITTING AN IN LINE WATER
FILTER TO REDUCE LIME SCALE BUILD UP AND
IMPROVE THE QUALITY AND TASTE THE ICE
WARNING
LIME SCALE BUILD UP WILL REDUCE THE
EFFICIENCY OF THE ICE MAKER AND COULD
LEAD TO COMPONENT FAILURE WHICH WOULD
NOT BE COVERED UNDER WARRANTY
WARNING
CONDENSER CLEANING MUST BE CARRIED
OUT BY A QUALIFIED ENGINEER
WARNING
FAILURE TO CLEAN YOUR CONDENSER COULD
CAUSE COMPONENT FAILURE AND WILL
INVALIDATE YOUR WARRANTY.
To Next Page
Loading...
