05. PUSH THE FLEXIBLE DRAIN HOSE ON THE
DRAIN SPIGOT AT THE REAR OF THE MACHINE
AND SECURE WITH THE CLIP PROVIDED. THE
DRAIN PIPE CAN BE CUT TO LENGTH TO ALLOW
THE DRAIN CONNECTION TO HAVE A SLIGHT FALL
IF NECESSARY
ALL ICE MACHINES HAVE BEEN FACTORY PRESET
BEFORE SHIPMENT. ADJUSTMENTS TO THE
PROGRAM OR SETTINGS ARE NOT REQUIRED
FOR A NEW ICE MAKER INSTALLATION. IN
ORDER TO ENSURE NORMAL OPERATION OF THE
ICEMAKER PLEASE REFER TO PART III OF THIS
MANUAL. ALWAYS REMEMBER THAT CHECKING
AND MONITORING OF THE ICE MAKER IS THE
RESPONSIBILITY OF THE OPERATOR.
PRE-INSTALLATION CHECK LIST
IS THE ICE MAKER INSTALLED ON A
HORIZONTAL AND LEVEL SURFACE?
HAS THE ICE MAKER BEEN LEVELLED USING
THE ADJUSTABLE FEET?
ARE THE WATER AND DRAIN PIPES
CONNECTED SECURELY WITHOUT LEAKS?
HAS ALL OF THE INNER AND OUTER
PACKAGING BEEN REMOVED FROM THE ICE
MAKER?
IS THE ICE MAKER CONNECTED TO A
SUFFICIENT AND SUITABLE POWER SUPPLY?
IS THERE PROPER VENTILATION AROUND
ALL SIDES OF THE ICE MAKER?
HAS THE ICE MACHINE BEEN CLEANED
INSIDE AND OUT?
IS THE MACHINE CORRECTLY EARTHED?
IS THE WATER TO THE ICE MAKER TURNED
ON?
IS THE POWER TO THE MACHINE SWITCHED
ON?
IS THE ICE MACHINE LOCATED IN A ROOM
WITH AN AMBIENT TEMPERATURE BETWEEN
10°C AND 32°C?
IS THE INLET WATER TEMPERATURE BETWEEN
7°C AND 20°C?
IS THE WATER PRESSURE BETWEEN 1.4 AND
5.5 BAR?
HAVE ALL USERS BEEN FULLY TRAINED IN
THE OPERATION OF THE ICE MAKER?
CL200718UM Rev 1.3
PART II
4
To Next Page
Loading...
