PART IV
MAINTENANCE AND CLEANING
PERIODIC CLEANING AND PROPER MAINTENANCE
WILL EXTEND THE LIFE OF YOUR ICE MAKER,
ENSURE MAXIMUM EFFICIENCY AND DELIVER
BETTER TASTING ICE TO YOUR CUSTOMER.
WARNING
DISCONNECT THE MACHINE FROM THE MAINS
ELECTRICITY BEFORE PERFORMING ANY
CLEANING OR MAINTENANCE
WARNING
INSPECTION, DE-SCALING AND SERVICING
SHOULD ONLY BE UNDERTAKEN BY A
QUALIFIED ENGINEER
WARNING
NEVER CLEAN THE ICEMAKER WITH A PRESSURE
WASHER OR BY SPRAYING WATER
WARNING
NEVER USE ACIDIC OR ABRASIVE DETERGENTS,
THESE TYPES OF CLEANERS MAY TRANSFER
TASTE AND ODOUR TO THE MACHINE AND
THE ICE. THIS TYPE OF CLEANER MAY ALSO
DAMAGE OR DISCOLOUR THE ICE MAKER.
WARNING
NEVER CLEAN STAINLESS STEEL WITH A
BLEACH BASED CLEANER AS THIS MAY CAUSE
CORROSION ON THE STAINLESS STEEL.
EXTERIOR CLEANING
ALWAYS CLEAN THE EXTERIOR STAINLESS STEEL
PARTS OF THE ICE MAKER WITH A MICRO-FIBRE
CLOTH AND OR A SPONGE. ALWAYS CLEAN IN
THE DIRECTION OF THE GRAIN OF THE STAINLESS
STEEL.
DO NOT USE ABRASIVE OR METALLIC PRODUCTS
(WIRE WOOL) WHICH COULD SCRATCH AND
DAMAGE THE SATIN FINISH OF THE ICE MAKER
PERMANENTLY.
USING A METALLIC CLEANING PRODUCT SUCH
AS WIRE WOOL WILL DEPOSIT IRON PARTICLES
INTO THE STAINLESS STEEL WHICH COULD CAUSE
CORROSION OF THE STAINLESS STEEL FINISH.
INTERIOR CLEANING
CLEAN THE INTERIOR OF THE ICE BIN AND ALL
REMOVABLE PARTS BY WASHING THEM WITH A
SOLUTION OF LUKEWARM WATER AND A SMALL
AMOUNT OF DISH-WASHING LIQUID. RINSE AND
DRY IMMEDIATELY.
WARNING
THE ICE STORAGE BIN IS FOR STORAGE OF ICE
ONLY, NEVER STORE ANYTHING OTHER THAN
ICE IN THE STORAGE BIN AS THIS IS A HEALTH
HAZARD.
CL200718UM Rev 1.3
7
WARNING
ALWAYS TURN THE POWER OFF TO THE
MACHINE BEFORE TURNING OFF THE WATER
SUPPLY. IN THE EVENT OF A WATER SUPPLY
FAILURE PLEASE DISCONNECT THE MACHINE
FROM THE ELECTRICITY IMMEDIATELY
WARNING
NEVER TOUCH THE EVAPORATOR SURFACE
WHEN THE MACHINE IS RUNNING AS THIS MAY
CAUSE INJURY TO THE USER
WARNING
KEEP THE DOOR CLOSED AT ALL TIMES
HARVEST STAGE: DURING THE HARVEST CYCLE
THE HOT GAS BYPASS VALVE IS OPENED AND HOT
GAS IS CIRCULATED THROUGH THE EVAPORATOR.
THIS ALLOWS THE ICE CUBES TO BE RELEASED
FROM THE EVAPORATOR INTO THE STORAGE BIN.
THE NEXT FREEZING CYCLE WILL BEGIN WHEN ALL
THE CUBES HAVE FALLEN INTO THE STORAGE BIN
UNLESS THE ICE FULL MODE IS ACTIVATED BY THE
BIN FULL SENSOR.
ICE FULL STAGE: WHEN THE ICE STORAGE BIN
IS FULL THE ICE CUBES WILL NOT BE ABLE TO
FULLY RELEASE FROM THE EVAPORATOR AND
WILL HOLD THE BIN FULL SENSOR OPEN. THE ICE
MAKER WILL ENTER ICE FULL STAGE AND THE BIN
FULL LED WILL ILLUMINATE AND A BLIP SOUND
WILL BE EMITTED.
THE ICE MAKER WILL AUTOMATICALLY RESTART
THE ICE MAKING STAGE WHEN ICE IS REMOVED
FROM THE BIN AND THE BIN FULL SENSOR CAN
RETURN TO ITS NORMAL POSITION.
To Next Page
Loading...
