PART II
01. THIS MANUAL IS AN INTEGRAL PART
OF THE ICE MAKER AND SHOULD BE KEPT
AND PRESERVED BY THE USER FOR FUTURE
REFERENCE. PLEASE READ THE INSTRUCTIONS
CAREFULLY FOR THE CORRECT INSTALLATION
METHOD, SAFETY WARNINGS AND MAINTENANCE
INFORMATION FOR THIS ICE MAKER.
02. THIS ICE MAKER IS DESIGNED FOR
COMMERCIAL USE AND SHOULD BE USED
FOR THE PURPOSE FOR WHICH IT HAS BEEN
EXPRESSLY DESIGNED. ANY OTHER USE SHOULD
BE CONSIDERED IMPROPER AND THEREFORE
DANGEROUS. THE MANUFACTURER WILL
NOT BE LIABLE OR RESPONSIBLE FOR ANY
DAMAGE CAUSED BY IMPROPER, INCORRECT OR
UNREASONABLE USE.
iv. REMOVE THE PROTECTIVE PLASTIC FILM
FROM THE EXTERIOR BEFORE INSTALLATION. IF
THE ICEMAKER HAS BEEN EXPOSED TO SUN OR
HEAT ALLOW THE ICE MAKER TO COOL DOWN
BEFORE REMOVING THE PROTECTIVE FILM.
iv. REMOVE THE ACCESSORY PACK AND CHECK
THE CONTENTS, IT SHOULD CONTAIN
1 x INLET WATER HOSE
1 x ICE SCOOP
1 x DRAIN HOSE
1 x INSTRUCTION MANUAL
IMPORTANT
WARNING
THE INSTALLATION OF THIS ICE MAKER MUST
BE CARRIED OUT BY QUALIFIED PERSONNEL IN
ACCORDANCE WITH CURRENT REGULATIONS
AND AS PER THE MANUFACTURERS
INSTRUCTIONS. FAILURE TO CORRECTLY INSTALL
THIS ICE MAKER COULD RESULT IN DAMAGE OR
INJURY AND WILL VOID THE WARRANTY.
INSTALLATION
01. UNPACKING
WARNING
KEEP ALL PACKAGING MATERIALS INCLUDING
BOXES, PLASTIC BAGS AND POLYTHENE OUT OF
REACH OF CHILDREN
IMPORTANT
i. REMOVE ALL SHIPPING MATERIALS, TAPE
AND PACKAGING FROM THE BOTH OUTSIDE
AND INSIDE THE ICE MAKER. IF PACKAGING
MATERIAL IS LEFT INSIDE THE ICE MAKER IT
WILL NOT FUNCTION CORRECTLY
ii. AFTER REMOVING THE PACKAGING MAKE
SURE THE ICE MAKER IS IN GOOD CONDITION.
IF IN DOUBT PLEASE DO NOT INSTALL OR USE
THE ICE MAKER AND CONTACT YOUR SUPPLIER
IMMEDIATELY.
iii. REMOVE THE SHIPPING TAPE WHICH IS
HOLDING THE DOOR AND FRONT PANEL
WARNING
THIS ICE MAKER IS NOT INTENDED
FOR OUTDOOR USE. NORMAL OPERATING
TEMPERATURES FOR THIS ICE MAKER ARE
BETWEEN 10°C AND 32°C. USE OF THIS
ICE MAKER OUTSIDE OF THE DEFINED
OPERATING PARAMETERS WILL AFFECT
PRODUCTION AND MAY DAMAGE THE UNIT.
01. ENSURE THERE IS A FREE FLOW OF CLEAN
AIR AVAILABLE ALL AROUND THE ICE MAKER.
02. THE ICE MAKER SHOULD NOT BE LOCATED
CLOSE TO A HEAT SOURCE (RADIATOR, STOVE
OR HEATER) OR EXPOSED TO DIRECT SUNLIGHT.
03. THE INSTALLATION LOCATION SHOULD
BE FIRM AND LEVEL AND ABLE TO SUPPORT
THE FULL WEIGHT OF THE ICE MAKER
WHEN LOADED WITH ICE AND WATER.
04. ALLOW AT LEAST 150MM CLEARANCE
AT THE REAR, BOTH SIDES AND TOP
OF THE ICE MAKER FOR PROPER AIR
CIRCULATION AND EASE OF MAINTENANCE.
05. THIS ICE MAKER IS NOT SUITABLE
FOR INSTALLATION IN AREAS WHERE
WATER IS FREE FLOWING OR HIGH
PRESSURE WATER JETS ARE USED
06. IF THE AMBIENT TEMPERATURE DROPS
BELOW 10°C THE UNIT SHOULD NOT BE USED.
IF THE AMBIENT TEMPERATURE DROPS BELOW
10°C WATER SHOULD BE DRAINED OUT OF THE
UNIT AND SUPPLY HOSES TO PREVENT DAMAGE
IF THE WATER FREEZES.
LOCATION
CL200718UM Rev 1.3
2
To Next Page
Loading...
