34
SYMPTOM: The displays of the console do not
function properly
a. If the console does not boot up properly, or if the
console freezes and does not respond, reset the
console to the factory default settings.
IMPORTANT: Doing this will erase all the
custom settings you have made to the console.
Resetting the console requires two people. First,
press the power switch into the off position. Next,
locate the small reset opening (E) port on the
console. Using a bent paper clip (F), press and
hold the reset button inside the opening, and have
a second person press the power switch into the on
position. Continue holding the reset button until the
console turns on. When the reset operation is
complete, the console will turn off and then turn
back on. If it does not, use the power switch to turn
the treadmill off and then on again. Once the
console turns on, check for rmware updates (see
HOW TO USE THE MAINTENANCE SECTION on
page 27). Note: It may take a few minutes for the
console to be ready for use.
E
F
a
To Next Page
Loading...
Need help?
General
