5. The mounting structure and the anchoring hardware must be capable of reliably
supporting the weight of the heater and if used the mounting bracket.
6. All electrical power must be disconnected and the main service box must be locked
before inspecting cleaning or servicing the hater. This is a precaution to prevent
serious electric shock.
7. This heater is not suitable for use in hazardous locations as defined by the national
fire protection association (NFPA) in the united states. This heater has hot and
arcing sparking parts inside. Do not use it in areas where gasoline paint or
flammable liquids are used or stored.
8. This heater is not suitable for use in corrosive atmospheres such as marine
greenhouses or chemical storage areas.
9. This heater must be mounted at least 8 feet off the floor.
Improper installation or failure to follow the procedures outlined in this
instruction manual can result in serious electrical shock.
LOCATING HEATER
Install heater out of traffic areas maintaining clearances stated in figure 2. The direction of
air flow should not be restricted is by columns or machinery and the air flow should wipe
exposed walls rather than blowing directly on them. When more than one heater is used in
an area the heaters should be arranged so that the air discharge of each heater supports
the air flow of the others to provide best circulation of warm air as indicated in figure 3.
4
To Next Page
Loading...
