6 | Page
MAKE SURE ALL CONNECTIONS ARE TIGHT. DO NOT OVER-TIGHTEN
CONNECTION ON THE BATTERY TO DETER DAMAGE TO TERMINALS OR
BATTERY CASE.
DO NOT LEAVE THE BATTERY ON A TRICKLE CHARGER FOR MORE THAN
48 HOURS.
BATTERIES SHOULD BE KEPT CLEAN AND FREE FROM ANY CORROSION.
USE A CORROSION DETERRENT SPRAY ON THE BATTERY TERMINALS TO
ENSURE LONGER LIFE.
IT IS CRITICAL THAT THE MPPT CHARGE CONTROLLER BE USED TO HELP
REGULATE THE BATTERY FROM OVER AND/OR UNDERCHARGING. IF NOT
THIS WILL SIGNIFICANTLY REDUCE THE LIFE OF THE BATTERIES.
CHARGE CONTROLLERS CAN NOT GET WET
• ALWAYS KEEP CONTROLLERS DRY AND COVERED FROM ELEMENTS. CLOSE
DOORS WHEN NOT ACCESSING ANY INTERNAL COMPONENTS.
SOLAR PANEL OR BATTERY REMOVAL / INSTALLATION SEQUENCE
SOLAR PANELS MUST BE DISCONNECTED FROM THE CONTROLLER FIRST,
BEFORE ANY WORK CAN BE DONE ON THE CONTROLLER OR BATTERIES.
Serial Number (VIN#) and Model numbers are attached on the lower portion of the front
or back of the unit.
Serial Number & Model Number Locations
To Next Page
Loading...
General