14
7. Insert the power supply cable, coming from the wall junction box,
through the strain relief connector. Tighten connector.
8. Connect disposal wire leads (black and blue) to corresponding wire
leads of the power supply cable. Green always connects to green.
9. Setting the wires into the endbell, replace the end plate and tighten
the two bolts.
OPERATING INSTRUCTIONS
The Anti-Jam Swivel Impellers make a clicking sound as they initially swing into place. This
indicates normal operation.
1. Remove sink stopper. Turn on a medium flow of cold water.
2. Turn switch to ON position; your motor is turning at full speed and ready to use.
3. Scrape in food waste. Down the drain go table scraps, peelings, rinds, seeds, pits, small
bones and coffee grounds. To speed up food waste disposal, cut or break up large bones,
rinds and cobs. Large bones and fibrous waste require considerable grinding time and are
more easily thrown away with other trash. Do not be alarmed that the disposer slows down
while grinding. The disposer is actually increasing torque (grinding power) and is operating
under normal conditions.
4. Before turning the disposer off, let water and disposer run for approximately 15 seconds after
shredding or grinding stops. This assures that all waste is thoroughly flushed through trap and
drain.
5. It is not recommended to use hot water while running disposer. Cold water will keep waste
and fats solid so disposer can flush away particles.
7
6G
8
6H
9
6I
To Next Page
Loading...