EasyManuals Logo

Projecta SC300D User Manual

Projecta SC300D
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
14
Charging mode Notes
Vol.Compen. Voltage compensation: Voltage control charging (default)
SOC By setting the charge and discharge SOC target values for battery charge
and discharge control
Factory reset
The default parameter values of solar charge controller could be restored via the Factory
reset page, which means the “Control parameter”, “Load setting”, “Charge mode” and
“Device password” of the devices could be restored to the factory defaults (the factory
default password of the devices is “000000”).
Failure information
The current failure information of the solar charge controller could be checked via
the Failure information page (a maximum of 15 failure messages could be displayed);
when the failures of solar charge controller are eliminated, the corresponding failure
information will also be automatically eliminated.
Meter parameter
The meter model, software and hardware version, and SN NO.could be checked via
Meter parameter page. And the three parameters (Switch pages, Backlight, Audible
alarm) could be browsed and modified as well.
Note: When the set up is accomplished, the auto switch page cannot become effective
until ten minutes later.
Factory Reset
Yes No
1. Over voltage
2. Over load
3. Short circuit
Failure Info.
2.
Type: MT50
Ver: Hardware + Software
SN: XXXXXXXXXX
1.
Meter Para.
Sw-Pages: XXS
BKLight: XXS
AudiAlarm: on/off
Meter Para.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Projecta SC300D and is the answer not in the manual?

Projecta SC300D Specifications

General IconGeneral
BrandProjecta
ModelSC300D
CategoryInverter
LanguageEnglish

Related product manuals