ProLights EclProfile CT+ - 10 Rdm Functions

Parameter PID GET SET
SUPPORTED_PARAMETERS 0x0050 x
DEVICE_INFO 0x0060 x x
DEVICE_MODEL_DESCRIPTION 0x0080 x
MANUFACTURER_LABEL 0x0081 x
DEVICE_LABEL 0x0082 x x
FACTORY_DEFAULTS 0x0090 x x
SOFTWARE_VERSION_LABEL 0x00c0 x
BOOT_SOFTWARE_VERSION_ID 0x00c1 x
BOOT_SOFTWARE_VERSION_LABEL 0x00c2 x
DMX_PERSONALITY 0x00e0 x x
DMX_PERSONALITY_DESCRIPTION 0x00e1 x
DMX_START_ADDRESS 0x00f0 x x
SENSOR_DEFINITION 0x0200 x
SENSOR_VALUE 0x0201 x
DEVICE_HOURS 0x0400 x
LAMP_HOURS 0x0401 x
LAMP_STRIKES 0x0402 x
DEVICE_POWER_CYCLES 0x0405 x
IDENTIFY_DEVICE 0x1000 x x
RESET_DEVICE 0x1001 x
PROLIGHTS - EclProfile CT+
16
10 - RDM FUNCTIONS
The product can communicate using RDM (Remote Device Management) protocol over a DMX512
Networks.
RDM is a bi-directional communications protocol for use in DMX512 control systems, it is the open
standard for DMX512 device conguration and status monitoring.
The RDM protocol allows data packets to be inserted into a DMX512 data stream without affecting
existing non-RDM equipment. It allows a console or dedicated RDM controller to send commands to
and receive messages from specic xtures.
The PIDs in the following tables are supported in the product.