54 ActivPanel User Guide
The pen tip (nib) will wear with normal use. Excessive pressure will cause it to wear sooner. If your
pen display has a coated surface a worn nib may cause damage. To avoid this, periodic tip replacement
is recommended.
When the nib gets too short or develops a sharp edge, replace it with one of the extra nibs that came
with the pen.
Replace the pen nib when it gets too short, or less than 1 mm (0.04 inch).
Warning:
Choking hazard. Prevent children from swallowing the pen nib or side switch. The pen nib or side switch
may accidentally be pulled out if children are biting on them.
Important:
When not in use, place the pen in the pen storage compartment or lay it flat on your desk. To maintain
the sensitivity of your pen, do not store the tool in a container where it will rest on its tip.
Clasp the old nib with a nib extraction
tool, pair of tweezers, needle-nosed
pliers, or similar instrument and pull it
straight out of the pen.
Slide the end of the new nib straight into
the barrel of the pen. Firmly push the nib
until it stops. The new nib will slide into
the correct position.
To Next Page
Loading...
Need help?
General
