ProMinent
®
Page 7
Controller
4 Controller
Version As electronics and software are continuously being improved, the version number has been
introduced as a means of identifying the system. This should be given in the event of a query or
complaint.
Default setting The controller system of the Dulcodes M UV system is preset at the factory. Unless calibrating
the sensor, it is not usually necessary to change the settings.
NOTE
The settings can only be changed if the UV system has been switched off.
Exceptions: sensor calibration, setting the lamp output and triggering a wiper cycle.
4.1 Display
The system has a graphical display.
In operating mode It indicates the operating status.
Flashing arrows and displays are used to issue a warning.
A flashing error message indicates a fault.
In programming mode The numerical values and settings that can be changed are indicated as flashing text.
NOTE
If none of the keys are pressed for 5 minutes, the display returns to the normal operating
status display automatically.
To Next Page
Loading...
