ProMinent Dulcodes M User Manual

ProMinent
®
Please read the operating instructions through completely before commissioning this equipment! Do not discard!
Any part which has been subject to misuse is excluded from the warranty!
Part No. 987340 ProMinent Dosiertechnik GmbH
• 69123 Heidelberg • Germany BA DS 007 07/05 GB
Operating Instructions
Dulcodes M
UV-System
Please affix device label here!

ProMinent Dulcodes M Specifications

General

Protection Class	IP65
Monitoring	UV sensor
Application	water treatment
Power Supply	50/60 Hz
Operating Temperature	5°C to 40°C
Dimensions	Varies depending on model
Weight	Varies depending on model

Summary

Safety Guidelines

Function

Commissioning

Overview of the system's commissioning process.

Normal Operation

Controlled Operation

Assembly and Installation

5.1.2 Assembly

5.1.4 Hydraulic Connections

Procedures for connecting the water inlet and outlet lines to the system.

5.2.2 Electrical Connections

Instructions for performing the electrical connections to the system.

5.3 Installing the Lamp Protection Tube

Steps for correctly installing the protective tube for the UV lamp.

5.4 Installing and Connecting the Lamp

Detailed guide on how to install and connect the UV lamp.

Commissioning

6.1 Checking Seals and Bleeding Radiation Chamber

6.2 Switching on the UV System

Guide to safely powering on and initiating the UV disinfection system.

6.3 Calibrating the UVC Sensor

Procedure to calibrate the UVC sensor for accurate performance measurement.

6.3.1 Calibrating the Sensor

Step-by-step guide for sensor calibration.

6.3.2 Setting Radiation Output (Control Off)

6.3.3 Setting Radiation Output (Control On)

6.3.3.1 Setting Radiation Output (Manual Control)

6.3.3.2 Setting Radiation Output (External Control)

Maintenance

7.1 Replacing the Lamp

Step-by-step instructions for replacing the UV lamp.

7.2 Cleaning the Lamp Protection Tube

7.3 Cleaning the UVC Sensor

7.3.1 Calibrating the Sensor

Guide to calibrating the sensor after cleaning.

Troubleshooting

Value Fallen Below Warning Threshold

System status when UV output is below the warning threshold.

Value Fallen Below Safety Threshold

System status when UV output is below the safety threshold.

Fault Message: Lamp

Error message indicating a problem with the UV lamp.

Fault Message: Lamp Current

Error message related to lamp current issues.

Fault Message: Earth Leakage

Error message indicating an earth leakage fault.

Fault Message: Temperature Measurement

Error message related to temperature measurement issues.

Fault Message: Water Temperature Too High

Fault Message: Wiper Fault

Flashing Double Arrow During Calibration

Fault Message: Power Supply Below Minimum

Fault Message: Bus Error

Fault Message: Memory Fault

Fault Message: Standard Settings

Fault Indication: Signal < 4 mA