13 User Manual
Join a Thermostat to the ProStat+ web portal
If the thermostat is connected to the local Wi-Fi access point but not yet joined to an existing
account, you may join the thermostat to the account by doing the following:
1. Log in to your ProStat+ web portal account.
2. Select the “Location” you want to add a thermostat into or select the “Add a Location” link
in the upper left-hand corner.
3. Select the “Add a New Thermostat” box. A screen will ‘pop-up’ asking for a six digit code.
4. Press the FAN button on the thermostat for 5 seconds.
5. Press the Warmer button on the thermostat.
6. A six digit code will appear on the thermostat’s display.
7. Enter the six digit code into your ProStat+ account
Wi-Fi Status Screens
Press and hold the FAN button on the thermostat for 5 seconds. When “Wi-Fi Setup” appears
on the display, press the MODE button. Pressing the up or down button will display the
following information:
• AP Name
• AP Signal Strength
• IP Address
• ProStat+ account Status
• API Status
To Next Page
Loading...
