15 User Manual
How to Change Settings in the Setup Screens
To enter the setup screens, press the MODE button, and simultaneously press FAN button for 5
seconds. Release the buttons when you see “Setup” on the display. Use the WARMER or COOLER
buttons to adjust the value of your selection. Press MODE to advance to the next setup step. Press
MODE and FAN together again to leave the setup screens.
Setting the Clock and Day (Setup Steps 1 & 2)
When your thermostat is connected to the ProStat+ web portal, the time and day of the week are
controlled by the app. There is no local adjustment, the ProStat+ web portal also adjusts the time
for Daylight Savings Time as well.
Adjusts the clock (Setup Step 1) - Use the Warmer/Up or Cooler/Down buttons to adjust the time.
Press the MODE button to advance to Step 2.
Select the day of the week (Setup Step 2) - Use the Warmer/Up or Cooler/Down buttons to
adjust the day.
Backlight (Setup Steps 3-6)
Backlight (Setup Step 3)
Off - Backlight turns on only with a button press and turns off after 8 seconds.
On - Backlight is on continuously.
Night Dimmer (Setup Step 4) - Selecting On allows for turning off the backlight of the display
during specific times of the day, usually at night.
Night Dimmer Start Time (Setup Step 5)
Night Dimmer Stop Time (Setup Step 6)
To Next Page
Loading...
