ProTeam PP10C - Maintenance 1; To be Checked up Regularly; Leakage

4. Maintenance
4.1 To be checked up regularly
4. Winter ing
Water supply and water flow
asics
Distinguishing condensation and
Prevent freezing: All water must be discharged from the unit before winter
Lack of water or air entering into the system influences the performance
and reliability of the unit.
Keep the area around the unit dry, clean and well ventilated. Clean the
area regularly to maintain good
and save energy.
but
y
fins of the evaporator. If the relative humidity is very high
this could be as much as several litres an hour. The water will run down
the fins into the base pan and drain out through the plastic drain fitting.
This fitting is designed to accept 3/4” PVC tubing which can be pushed on
by hand and run into a suitable drain. It is easy to mistake the
condensation for a leakage inside the unit.
A quick way to verify that the water is condensation
is to shut off the unit and keep the pool pump running. If the water stops
running out of the base pan, it is condensation .
Even quicker way is to test the drain water for chlorine ,
if there si no chlorine present, then it s condensation
The operation pressure of the refrigerant system should be serviced only
by a certified technician
Before the Heat Pump is shut down for the winter period all water in the
pump and water system must be to prevent freezing.
Water is from the lower water connection .
Before first the Heat Pump after a longer period the system must
be fully filled with water.
The pool filter should be cleaned regularly.
evaporator (energy collector) COP
(efficiency)
Shut the electrical supply. Clean the evaporator with warm
water (if possible, not under high pressure). Be careful not to damage
the collector fins. Do not open the cabinet.
Since the Heat Pump cools down the air about 10 degrees, water ma
condense on the
, and not a leakage,
water
with the pool tester
i (in case that the pool
is sanitized with chlorine).
, preferably by a Proteam workshop.
,
drained (discharged)
drained (water inlet to the unit)
starting
Surroundings of the unit
Cleaning:
Condense water b
pool water inside the heat pump
4.2. Leakage
3 IMPORTANT: iz
17