Safety Precautions
The Protectowire Company, Inc. assumes no liability for the
customer’s failure
to comply with these requirements.
Do not remove instrument covers when operating.
Ensure that the instrument is switched off throughout
the cleaning procedures.
Even there is no direct danger for the eyesight because
of the low laser power we suggest to not look directly
into an optical device attached to an optical output
when the device is operational.
Use of controls or adjustments or performance of
procedures other than those specified may result in
hazardous laser radiation exposure.
To prevent electrical shock, disconnect the instrument
from the mains before cleaning. Use a dry cloth, or one
slightly dampened with water, to clean the external
case parts.
Do not open the card cage inside the FIBERSYSTEM
8000, or attempt to
clean it internally.
Do not install parts or perform any unauthorized
modification to optical devices.
Refer servicing only to qualified and authorized
personnel.
Service adapter for E2000 (see following picture), article
number N4385-43201 (one adapter is supplied with the
instrument)
Cleaning paper for connectors, article number N4385-88501
(package of 10 sheets, supplied with the instrument).
The Protectowire Company, Inc.
FIBERSYSTEM 8000 - Linear Heat
Series
To Next Page
Loading...
Need help?
General