Protectowire FiberSystem 8000 User Manual

Troubleshooting and Maintenance
Replacing the Fuse
2
1.
2.
Unplug the power supply.
On the bottom of the card cage assembly, use a flat-tipped
screwdriver to open the fuseholder.
Pull the fuse holder and fuse clear of the back panel.
Take the fuse out of the fuse cap and note the fuse rating.
Make sure the replacement fuse (4A, 250V, The Protectowire
Company, Inc. part no. 312004) has the same rating.
Put the fuse into the fuse holder.
Put the fuse and fuse cap into the receptacle in the rear of the
case and press it into place.
3.
4.
5.
6.
7.
32
The Protectowire Company, Inc.
FIBERSYSTEM 8000 - Linear Heat
Series

Protectowire FiberSystem 8000 Specifications

General

Brand	Protectowire
Model	FiberSystem 8000
Category	Controller
Language	English