16
1
Slide active sash almost closed, leaving
enough room to align keeper with lock body.
Mark jamb pocket with the location of top
and bottom keeper as aligned with lock
body. (Figure I.1)
Tip: Place (2) strips of double-sided tape
on back of keeper. Locate keeper onto lock
body and lock in place. Close sash tight to
adhere keeper to jamb pocket. Unlock the
lock body and open sash. Install keeper as
directed below.
2
3
Center keeper on jamb pocket score line
between marks made. Install (1) #10 x 1"
screw in each elongated screw hole
locations. This will allow for a slight up and
down adjustment if needed. (Figure I.1)
4
Close active sash, locking and unlocking
handle. If needed, adjust the latch bolt and
keeper positions until sash latches securely
without sash movement or excessive
latching effort. To adjust latch bolt position,
open sash and engage the anti-slam button
to allow the latch bolt to lock. Use a flat
head screwdriver to loosen or tighten latch
bolt as needed. Test function of the lock.
Repeat step if lock is still too tight or too
loose. (Figure I.1)
After final adjustments are completed,
install (1) #8 x 3" screw (Pack #2) at top
and bottom of the keeper to secure in place.
(Figure I.2)
(Figure I.1)
Vinyl score line
Align keeper
with lock body
and mark top
and bottom
location
Latch bolt
adjustment
Anti-slam
button
Latch bolt
adjustment
Keeper Lock Body
I. INSTALL KEEPER
(Figure I.2)
Keeper in Jamb Pocket
After adjusted, install (1) #8 x 3" screw in the
top and bottom keeper screw hole location
To secure,
install (1) #10 x
1" screw in each
elongated screw
hole location
5
Place shims immediately above each top
and bottom keeper screw location.
(Figure I.2)
Place shims above top and bottom
screw location
Interior
Side
Exterior
Side
To Next Page
Loading...