INSTALLATION PRO-VISION® Video Systems
DVR-906M SYSTEM GUIDE
50 provisionusa.com
Solid-State Drive (SSD) Installation
The DVR has the capability of adding an additional high capacity solid state storage device. This drive
can be used in addition to or instead of the included SDXC Card.
Solid-State Drives (SSD’s) are available in the following configurations:
DVR-830 – 500GB
DVR-831 – 1TB
DVR-832 – 2TB
Installation:
To install, remove the two Philips head screws on the the “PRO-VISION” front panel on the DVR and then
slide the SSD in the open slot. Use the same screws to secure the SSD in place.
The DVR will default to storing information on the SSD even if a removeable SDXC card is installed in the
DVR. When the SSD is full, the DVR will write over the non-alarm data files. It will write to the removeable
SD installed only when the SSD is completely full of alarm data. The DVR settings can be changed to
prevent writing over existing data. If that option is chosen, the data will need to be downloaded and
removed from the SSD to allow the DVR to continue recording.
In the event of SSD failure, or if the SSD is removed, the DVR will automatically continue recording to the
SDXC card if present.
Caution! Do not remove the SSD from the its mounting tray, this tray includes all the relavent warranty
information for the product including is size identification and serian number. If the drive is
removed from the tray the warranty will be void.
To Next Page
Loading...