201
Configure DHCP Relay
Perform the following command to enable or disable DHCP Relay Agent Status.
NOTE: You must have at least one entry in the DHCP Relay Server Table before you can set the DHCP Relay Status to
Enable.
[Device-Name]>set dhcprelaystatus enable
Configure DHCP Relay Servers
Perform the following command to configure and enable a DHCP Relay Server. The AP allows the configuration of a
maximum of 10 server settings in the DHCP Relay Agents server table.
[Device-Name]>set dhcprlyindex 1 dhcprlyipaddr <ip address> dhcprlycmt <comment>
dhcprlystatus 1 (1 to enable, 2 to disable, 3 to delete, 4 to create)
Maintain Client Connections using Link Integrity
[Device-Name]>show linkinttbl (this shows the current links)
[Device-Name]>set linkinttbl <1–5 (depending on what table row you wish to address)>
ipaddr <ip address of the host computer you want to check>
[Device-Name]>set linkintpollint <the interval between link integrity checks>
[Device-Name]>set linkintpollretx <number of times to retransmit before considering the
link down>
[Device-Name]>set linkintstatus enable
[Device-Name]>show linkinttbl (to confirm new settings)
[Device-Name]>reboot 0
Change Wireless Interface Settings
See Interfaces for information on the parameters listed below. The AP uses index 3.
Operational Mode
[Device-Name]>set wif 3 mode <see table>
Autochannel Select (ACS)
ACS is enabled by default. Reboot after disabling or enabling ACS.
[Device-Name]>set wif 3 autochannel <enable/disable>
[Device-Name]>reboot 0
Dynamic Channel Selection (DCS)
[Device-Name]>set dcs <1 (enable)/2 (disable)>
[Device-Name]>set dcsthreshold <value 1-10>
Mode Operational Mode
1 dot11b-only
2 dot11g-only
3 dot11bg
4 dot11a-only
5 dot11g-wifi
To Next Page
Loading...
