203
Set Ethernet Speed and Transmission Mode
[Device-Name]>set etherspeed <value> (see below)
[Device-Name]>reboot 0
Set VLAN parameters
[Device-Name]> set ethvlanmode <value 0-3>
This command is configured to select any of the four modes. The values represent the four VLAN modes. They are as
follows:
0-Transparent Mode
1-Trunk Mode
2-Access Mode and
3-Mixed Mode.
[Device-Name]>ethvlanaccessid <value 1-4094>
This command stands for the Access VLAN ID configuration. The values range from 1 to 4094.
[Device-Name]>set ethvlanpriority <value 0-7>
For Access VLAN Priority, there are eight values. The default is 0 and the maximum is 7.
[Device-Name]>set ethvlanid01-16 <value -1-4094>
For the VLAN 1 to 16, the values range from -1 to 4094. The value -1 represents the untagged frames.
Set Interface Management Services
Edit Management IP Access Table
[Device-Name]>set mgmtipaccesstbl <index> ipaddr <IP address> ipmask <subnet mask>
Value Distance Between APs
1 Large
2Medium
3Small
4Mini
5Micro
Ethernet Speed and
Transmission Mode
Value
10 Mbits/sec - half duplex 10halfduplex
10 Mbits/sec - full duplex 10fullduplex
10 Mbits/sec - auto duplex 10autoduplex
100 Mbits/sec - half duplex 100halfduplex
100 Mbits/sec - full duplex 100fullduplex
Auto Speed - half duplex autohalfduplex
Auto Speed - auto duplex autoautoduplex (default)
To Next Page
Loading...
