PSC PowerScan Handheld Laser Scanner - General Features; Programming the General Features; Green LED Lamp Idle State

132 PowerScan
®
Scanner
General Features
The following section contains the general features that are common to
all interfaces. These features allow modification of the scanner's behav-
ior to accommodate user preferences.
• Green LED Lamp Idle State
• Beeper Settings
• Marker Beam Settings
• AutoSense® Stand Mode
• Low Power Mode
• Low Power Shut-down Delay
• Half-Angle
• Multiple Read Mode
Programming the General Features
Use the special bar codes on the following pages to configure the fea-
tures common to all interfaces.
Green LED
Lamp Idle
State
When the scanner is idle, its green LED lamp can be programmed to
indicate this in one of two ways:
• LED lamp is OFF when the scanner is idle.
• LED lamp is ON when the scanner is idle.
SET -------------------------------------------
LED OFF ---------
LED ON ---------
END ------------------------------------------