36 PowerScan
®
Scanner
Connect to a
Laptop/No
Keyboard
Attached
If no keyboard is attached, the scanner must provide the acknowledge
signal to the PC. In this case, enable the "Laptop/No External Key-
board" mode. If a keyboard is attached, enable "Keyboard Attached."
Laptop (integrated keyboard) -provides the acknowledge signal to the
PC when the scanner is connected to a laptop computer or when the
scanner is operated with no external keyboard.
PC (external keyboard) - is enabled when the scanner is connected to a
standard PC."
Send Control Characters - transmits all ASCII characters except NUL
(00h) . Disabling this feature limits transmission of ASCII characters to
the following:
• Only ASCII characters between 20h..127h, plus.
- Carriage Return (CR=0Dh)
- BackSpace (BS=08h)
- Right Tab (HT=09h)
-Left Tab (0Bh)
-Esc (1Bh)
Send Function Character - transmits characters between 00H - IFH
which are not in the normal ASCII set.
Scan the bar code belows below to select the applicable option for con-
necting to a laptop or PC.
SET -------------------------------------------
Connect to Laptop or PC
Laptop/No external
Keyboard ---------
Keyboard Attached ---------
To Next Page
Loading...
