PSC PowerScan Handheld Laser Scanner - Page 25

Programming Guide 19
Post-Noise Settings
Set Pre-Noise Transitions ---------
Scan two digits representing the desired number of Pre-Noise Transitions
using the number pad from Appendix C: Keypad, padded with leading zeros
(example: 03 = three transitions, 08 = eight, 15 = fifteen, etc.)
END ------------------------------------------
SET -------------------------------------------
Post-Noise
Don’t Transmit Post-
Noise ---------
Set Post-Noise Transitions ---------
Scan two digits representing the desired number of Post-Noise Transitions
using the number pad from Appendix C: Keypad, padded with leading zeros
(example: 03 = three transitions, 08 = eight, 15 = fifteen, etc.)
END ------------------------------------------