PSL PQube - Page 75

PQube User Manual 2.1
Page 75 of 113
146-147
Harmonic – L3-
N volts
Float
RMS
Volts
Harmonic order specified in 166
148-149
Harmonic – L1
current
Float
RMS
Amps
Harmonic order specified in 166
150-151
Harmonic – L2
current
Float
RMS
Amps
Harmonic order specified in 166
152-153
Harmonic – L3
current
Float
RMS
Amps
Harmonic order specified in 166
154-155
Harmonic – L1-
N voltage
angle
Float
degrees
Harmonic order specified in 166
156-157
Harmonic – L2-
N voltage
angle
Float
degrees
Harmonic order specified in 166
158-159
Harmonic – L3-
N voltage
angle
Float
degrees
Harmonic order specified in 166
160-161
Harmonic – L1
current angle
Float
degrees
Harmonic order specified in 166
162-163
Harmonic – L2
current angle
Float
degrees
Harmonic order specified in 166
164-165
Harmonic – L3
current angle
Float
degrees
Harmonic order specified in 166
166
Harmonic
order of
interest
Integer
(Read/Write)
-
Range: 1-50, selected by user on
PQube harmonic meters screens –
defaults to 3
rd
harmonic
167
GPS status
Integer
-
0 = not installed
1 = not locked
2 = locked onto satellites and
operating
168-169
GPS latitude
Float
degrees
Range: ±90.0000° from equator
170-171
GPS longitude
Float
degrees
Range: ±180.0000° from prime
meridian
172
GPS number of
satellites
Integer
-
Count of acquired satellites
173
-
-
-
(Not used)
174-175
IEC or GB
Unbalance – V-
Float
Percent
Fundamental negative-sequence
voltage, as a percentage of
fundamental positive-sequence
voltage
176-177
IEC or GB
Unbalance – A-
Float
Percent
Fundamental negative-sequence
current, as a percentage of
fundamental positive-sequence
current
178-179
IEC or GB
Unbalance –
V0
Float
Percent
Fundamental zero-sequence
voltage, as a percentage of
fundamental positive-sequence
voltage
180-181
IEC or GB
Unbalance –
A0
Float
Percent
Fundamental zero-sequence
current, as a percentage of
fundamental positive-sequence
current
182-183
DC Power
Float
Watts
DC volts multipled by DC amps
184-185
DC Energy
Float
Wh
DC energy accumulated since [date]
– see registers 242-244
186-189
User counter
Long Long
counts
Number of times the Analog or
Digital Input channels were
triggered since [date] – shares this
reset date with Energy, see registers
131-133
190
Trigger
Snapshot
Write-only
-
Set this register to 1 to trigger a
Snapshot with your PQube
191
Reset Peak
Measurements
Write-only
-
Set this register to 1 to reset all peak
measurements in your PQube
192-193
L1 Voltage
THD
Float
Percent