PTN WP8 - Page 18

Programmable Control Panel
PTN Electronics Limited 15 www.PTN-electronics.com
 I/O Setting
There is no I/O port in WP8, so the setting is not introduced in this manual.
 Relay Setting
This item is for the replay ports setting. The setting is as the picture below:
 Delay setting
This item is to set a delay time, user can add a delay between two events; so when
one event is finished, it will delay a certain time then start another event. The delay
setting is as picture below:
Send
Type
Port Action: “On”
for connected, “Off”
for disconnected.