Pulsar 3 - Table of Contents

2 pulsar 3
Table of content
Chapter Page
_____________________________________________________________
1. Device description 1
2. Technical specification 3
3. Precautions 3
4. Scope of use 3
5. EU – certificate of conformity 4
6. Features 4
7. Definitions, abbreviations and symbols 4
 Battery types 4
 Modes 4
 Parameters and abbreviations 4
8. Starting and operating 5
 Connecting the balancer 6
 Cautions 6
9. Batteries (attributes) 7
10. Operating principle – general description 7
 Main menu 7
 Program window 7
11. „SD, BT, RTC“ settings 8
 Memory window 8
 Personalization through an SD memory card 8
12. Additional information concerning SD memory cards 9
13. Basic setup settings 9
14. Process set-up – charging NiCd and NiMH cells 10
15. Process set-up – charging LiXX and NiZn cells 10
16. Process set-up – charging Pb cells 11
17. Process set-up – discharge (all cell types) 12
18. Double processes set-up e.g. charging/discharging 13
19. Process set-up – Store / Condit (only LiXX) 13
20. Process set-up – Format (only NiCd and NiMH cells) 14
21. Balancer – operating 14
22. Process set-up – balancing only (Monitor) 15
23. Prozess set-up – Test 15
24. Program windows of finished processes 15
25. Process initialization 17
26. Process end, reports and alarms 17
 Alarms – interrupting the process 17
27. Updating the software 18
28. PC software (PulsarGraph) 19
29. Appendix 1 – Balancer adapter 22
30. Index 24