Attaching Wheels (See fig 1)
•
Parts needed - 2 wheels, 2 axles, 2 washers and 2 hair pins.
•
Raise or tilt generator so you can slide the wheel axle pin into the wheel, the washer, and the wheel mounting hole
located on the side of the frame.
•
Secure the wheel assembly by inserting a hair pin through hole at the end of the wheel axle clevis pin and pressing until
it locks into place.
•
Repeat process on the other side of the generator to install the second wheel.
Fig 1
Installing Support Leg (See fig 2)
•
Parts needed - Support Leg (2) & M8 screw (2) and 2 nuts.
•
Raise the front end of the generator high enough to gain access to the bottom of the frame. Securely position
props underneath to support.
•
Line up holes on the support leg bracket to the holes on the front of the generator frame.
•
Attach the support leg using M8 screws (2) and nuts.
Fig 2
To Next Page
Loading...
